Rodeo S 2WD L4-2.2L (1999)
4.
Disconnect the ABS harness connector (H-26) at the left-side upper-link arm. (Figure 2)
5.
Cut band clip (on side of frame, near the frame-side bushing of upper-link) to release attached harness. (Figure 3)
^
Pull the cut clip out and discard.
6.
Partially separate the plastic wire loom from the vehicle ABS harness and cut the (3) wires to even length. (Figure 4)
NOTE
If there are any corrosion or fraying at the ends, be sure to cut off that portion.