Rodeo S 2WD L4-2.2L (1999)
Power Steering Pump: Service and Repair
Removal and Installation
REMOVAL
1. Remove the drive belt.
2. Remove the pulley.
3. Place a drain pan below the pump.
4. Disconnect the suction hose.
5. Disconnect the flexible hose.
6. Remove the power steering fixing bolt and remove the pump assembly.
INSTALLATION
1. Install the pump assembly to the pump brakes, tighten the fixing bolt to the specified torque. Torque to 46 Nm (34 ft. lbs.).
2. Install the flexible hose. Tighten the eye bolt to specified torque. Torque to 54 Nm (40 ft. lbs.).
3. Install the pulley and tighten the nut to the specified torque. Torque to 78 Nm (58 ft. lbs.).
4. Install the drive belt.
5. Connect the suction hose, then fill and bleed system.
