Rodeo S 2WD L4-2.2L (1999)
5. Disconnect the feed line and return line from steering unit. Remove the clips on the crossmember and frame. Wire the power steering line to frame.
NOTE: Take care to prevent foreign matter from entry when disconnect the power steering line.
6. Remove the power steering unit from the crossmember.
INSTALLATION
1. Install power steering unit to crossmember. Tighten fixing bolt to specified torque. Torque to 116 Nm (85 ft. lbs.)
2. Connect the feed line and return line. Torque to 25 Nm (18 ft. lbs.)
3. Install tie-rod end assembly to knuckle. Torque to 118 Nm (87 ft. lbs.)
4. Install transfer gear assembly. Align the setting marks made at removal. Torque to 31 Nm (23 ft. lbs.)
5. Install the stone guard.
6. Bleed the system.
