Rodeo S 2WD L4-2.2L (1999)
Figure 7: Loosen the bolt and nut of No.1 body mount.
8.
Loosen the No.1 body mount bolt and nut. Do not remove the bolt from this mount. (Figure 7)
9.
Partially lift the body away from the frame using a floor-jack, equipped with a body lifting adapter tool J-44267, under body flange rail at
mid-point of front door.
Figure 8: Lift the body a small amount using lift adapter and floor jack.
IMPORTANT
Lift the body only to the amount required for shim installation. Excessive lifting height with the jack may damage the body or other components.
(Figure 8)
Figure 9: Add 2 shims at the top of the No.2 mount.
10.
Add 2 shims to top of No.2 body mount bushing (1)between the body and mount), reinstall the body mount bolt through access hole, and
hand-thread the bottom nut. (Figure 9)