Rodeo S 2WD L4-2.2L (1999)
Figure 12: Torque the bolt and nut to 50 N.m (37 lb. ft.).
14.
Tighten and torque the No.3 body mount bolt and nut to specification: 50 N.m (37 lb. ft.) (Figure 12)
Figure 13: Torque the bolt and nut to 50 N.m (37 lb. ft.).
15.
Tighten and torque the No.1 body mount bok and nut to specification: 50 N.m (37 lb. ft.) (Figure 13)
16.
Repeat Step 5 through Step 15 for the other remaining side.
17.
Remove any body undercoating residue from your hands prior to reinstalling the interior parts.
^
Undercoating residue is difficult to remove if stained in vehicle interior.
18.
Reinstall the following interior parts for both sides:
^
All Removed access plugs (4)
^
Interior carpet (fit into place)
^
Front and rear door sill plates and kick panels
19.
Verify the repair by re-measuring the upper clearance gap of the No.1 body mount. Specification: At least 2 mm or greater. (2 mm)
STEERING YOKE SPRING INSTALL & STEERING COUPLING INSPECTION
1.
Adjust the steering wheel to center position.
2.
Lift vehicle.
3.
At the bottom of the steering rack, locate the yoke plug and clean the plug and the surrounding surface.
