Rodeo S 2WD L4-2.2L (1999)
45.
Proceed to Step 46 for 1998 - 2000 2WD Vehicles. Proceed to Step 50 for 2001 and 4WD Vehicles.
Section F: REAR HUB CENTERING RINGS
This section pertains only to 1998 - 1999 and 2000 RODEO 2 Wheel Drive vehicles built prior to VIN breakpoint:
2Y4329627. If you are working on a 4Wheel Drive vehicle that still exhibits body vibration, go to Step 50 in Section G "Tire Balancing Procedures."
46.
Lift the vehicle and remove the rear wheels.
47.
Clean any dirt build-up on the axle hub area. Install the rear wheel centering ring by sliding it onto the axle hub. (Figure 25)
48.
Clean the frame thoroughly, remove any dirt or grease and install the Centering Ring Information Label to the frame. (Figure 26)
49.
Repeat steps 47 through 48 for the other side.
Section G: TIRE BALANCING PROCEDURE TIRE/WHEEL VIBRATION DIAGNOSIS USING A 2 DIMENSIONAL DYNAMIC BALANCER
IMPORTANT:
Dynamic tire balancing is required for this operation.
50.
With the vehicle on the hoist, remove all four wheels.
51.
Inflate the tires to 50 psi to seat the bead.
52.
Lower the tire pressure according to the vehicle's specified tire pressure located on the driver side B-pillar or the owner's manual.
