Rodeo S 2WD L4-2.2L (1999)
Wheels: Service and Repair
REMOVAL
1. Loosen wheel lug nut by approximately 180 g (half a rotation), then raise the vehicle and remove the nuts.
2. Remove wheel and tire.
NOTE: Never use heat to loosen a tight wheel lug nut. The application of heat to the hub can shorten the life of the wheel and may cause damage
to wheel bearings.
INSTALLATION
1. Install wheel and tire.
2. Install wheel lug nut, and lower the vehicle. Tighten the wheel lug nuts to the specified torque in numerical order. Torque to 118 Nm (87 ft. lbs.).
CAUTION: Before installing wheels, remove any build-up of corrosion on the wheel mounting surface and brake disc mounting surface by
scraping and wire brushing. Installing wheels without good metal-to-metal contact at mounting surfaces can cause wheel nuts to loosen, which can
later allow a wheel to come off while the vehicle is moving.
NOTE: Valve caps should be on the valve stems to keep dust and water out.
