Rodeo S 2WD L4-2.2L (1999)
1.
The bellhousing bolt located two holes above the starter motor must be no longer than 40 mm. If a longer bolt is used, it will break into
the engine coolant jacket.
2.
Before installing the converter to the drive plate bolts, push the converter into the transmission and check the gap between the converter
and drive plate. A 10 mm gap or more must exist otherwise the oil pump will be damaged when the engine is started. If the gap is too
small, remove the transmission, then turn and push the converter to engage the pump.
69.
Set the transmission fluid level. See appropriate Service Manual.
70.
Test-drive the vehicle.
