isuzu Workshop Repair Guides

Isuzu Workshop Service and Repair Manuals

A/T - 4L30E MIL ON/DTC P1870 Stored in PCM|Page 2865 > < Fluid Pan, A/T|Specifications
Page 1
background image

Technical Service Bulletin # SB02-05-S003

Date: 021201

A/T - 4L30E MIL ON/DTC P1870 Stored in PCM

BULLETIN NUMBER:
SB02-05-S003

ISSUE DATE:
DECEMBER 2002

GROUP:
TRANSMISSION

DTC P1870 AND THE 4L30E AUTOMATIC TRANSMISSION

AFFECTED VEHICLES

1996-1999 Rodeo (UE), Amigo (UA), Trooper (UX), and Vehicross (VX) with the 4L30E automatic transmission.

SERVICE INFORMATION

Condition:

Transmission indicator light may be on and DTC P1870 is set in the PCM (Powertrain Control Module).

Possible Cause:

Improper torque of the main case bolts permitted the adapter plate gaskets to slip out of position. The out of position gasket created an internal hydraulic
pressure leak that created low fluid pressure to the lockup clutch.

Correction:

Follow the procedures in this bulletin to replace the adapter plate gaskets.

SPECIAL TOOL REQUIREMENTS

-

Kent-Moore P/N J-8763-02 (Trans Holding Fixture) & J-3289-20 (Base)

-

Kent-Moore P/N J-23327 (Reverse Spring Seat Compressor)

-

Kent-Moore P/N J-38588 (two 9 inch Guide Pins)

-

Kent-Moore P/N J-38558 (Turbine Shaft Seal Installer & Sizer)

A/T - 4L30E MIL ON/DTC P1870 Stored in PCM|Page 2865 > < Fluid Pan, A/T|Specifications