isuzu Workshop Repair Guides

Isuzu Workshop Service and Repair Manuals

ABOUT US
Shift Cable, A/T|Service and Repair|Page 2979 > < Ignition Switch - Won't Turn to The Lock Position|Page 2974

Rodeo S 2WD L4-2.2L (1999)

Page 1
background image

Shift Cable: Service and Repair

SELECT CABLE 

Removal
1. Set selector lever in "P" position.
2. Remove transfer control lever knob, lower cluster assembly, rear console, center console, selector lever knob and cover.

3. Disconnect inner cable by pulling projection on pin.

4. Press down claws and disconnect cable assembly.
5. Disconnect PCM harness connectors and remove nuts that fasten grommet in select cable assembly.

6. Disconnect inner cable.

7. Press down claws and disconnect cable assembly.

Shift Cable, A/T|Service and Repair|Page 2979 > < Ignition Switch - Won't Turn to The Lock Position|Page 2974