Rodeo S 2WD L4-2.2L (1999)
1. Visually inspect the disassembled piston and piston cup for excessive wear and damage.
Replace the inner parts with new parts if necessary.
2. Measure the clearance between slave cylinder wall and piston.
If the measured value exceeds the specified limit, the slave cylinder assembly must be replaced.
Standard: 0.07 mm (0.0028 inch)
Limit: 0.15 mm (0.0059 inch)
REASSEMBLY
To reassemble, follow the disassembly steps in the reverse order, noting the following points:
Piston Assembly
1. Before installing the parts, apply a thin coat of rubber grease.
2. Install cup in groove in piston with the lip turned to the front of cylinder. Use care so as not to scratch the cylinder.
