Rodeo S 2WD L4-2.2L (1999)
NOTE: Do not drive in, but just temporarily set in the outer bearing by hand, which should be indirectly pressed in finally by tightening the flange
nut.
3. By using the seal installer J-37263, install a new oil seal (1) that has grease on seal lip.
4. Install flange.
5. The pinion washer and a new nut while holding the pinion flange with J-8614-01.
-
Tighten the nut until the pinion end play is just taken up. Rotate the pinion while tightening the nut to seat the bearings. Once there is not end
play in the pinion, the preload torque should be checked.
-
Remove J-8614-01. Using an inch-pound torque wrench, check to make sure the pinion preload is equal to or slightly over the reading
recorded during removal.
6. Install propeller shaft to the flange.
7. Install bolt and nut. Tighten the bolt and nut to the specified torque.
Torque: 63 Nm (46 ft. lbs.)
