Rodeo S 2WD L4-2.2L (1999)
Torque Converter Clutch Solenoid: Service and Repair
REMOVAL
1. Raise the vehicle and support it on jack stands.
2. Disconnect battery ground cable.
3. Drain fluid.
4. Remove adapter case oil pan twelve fixing 10 mm screws, adapter case oil pan, and gasket.
NOTE: Oil pan still contains transmission fluid. Place a large drain container under the oil pan and drain the fluid carefully.
5. Disconnect wiring harness from force motor solenoid and converter clutch solenoid. Pull only on connectors, not on wiring harness.
6. Remove 11 mm bolt and converter clutch solenoid with two O-rings.
7. Remove 11 mm bolt, retainer, and force motor solenoid.
INSTALLATION
1. Install force motor solenoid, retainer, and 11 mm bolt to adapter case valve body. Tighten the bolt to the specified torque.
Torque: 10 Nm (87 inch lbs.)
2. Install converter clutch solenoid with two O-rings, and 11 mm bolt to adapter case valve body. Tighten the bolt to the specified torque.
Torque: 10 Nm (87 inch lbs.)
3. Connect wiring harness assembly to solenoids.
4. Install adapter case oil pan, new gasket, and twelve 10 mm screws. Tighten the screws to the specified torque.
Torque: 11 Nm (96 inch lbs.)
5. Fill transmission through overfill screw hole oil pan, using ATF DEXRON III.
6. Connect battery ground cable.
