Rodeo S 2WD V6-3.2L (1998)
Suspension Strut / Shock Absorber: Service and Repair
Front Suspension
REMOVAL
1. Raise the vehicle and support it with suitable safety stands.
2. Remove wheel and tire assembly.
3. Remove bolt and nut.
4. Remove nut.
5. Remove rubber bushing and washer.
6. Remove shock absorber.
7. Remove rubber bushing and washer.
INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear, damage, corrosion or any other abnormal condition are found through inspection. Check the
following parts:
-
Shock absorber
-
Rubber bushing
INSTALLATION
1. Install rubber bushing and washer.
2. Install shock absorber.
3. Install rubber bushing and washer.
4. Install nut, then tighten it to the specified torque. Torque to 20 Nm (14 ft. lbs.).
5. Install bolt and nut, then tighten to the specified torque. Torque to 93 Nm (69 ft. lbs.).