isuzu Workshop Repair Guides

Isuzu Workshop Service and Repair Manuals

A/C - Insufficient Cooling During Maximum A/C Operation|Page 5230 > < Air Conditioning Switch|Testing and Inspection
Page 1
background image

Air Door: All Technical Service Bulletins
A/C - Insufficient Cooling During Maximum A/C Operation

BULLETIN NUMBER:
IB00-12-S001

ISSUE DATE:
JUNE 2000

GROUP:
AIR CONDITIONING

INSUFFICIENT COOLING DURING A/C OPERATION

AFFECTED VEHICLES

All 1998 - 2000 Rodeo (UE) models

SERVICE INFORMATION

Insufficient or poor cooling, during maximum A/C operation has been reported on 1998 - 2000 Rodeo (UE) vehicles. The complaint of insufficient
cooling may be related to heated air mixing with refrigerated air, while the temperature knob is in the "FULL COLD" position (the Temperature Door
Lever is closed at this position). The Air Mix Door and the Temperature Door Lever must be inspected at the "FULL COLD" (closed) position. To
properly determine if the Air Mix Door and the Temperature Door Lever is in the "FULL COLD." (closed) position, remove the glove box and perform
the following steps:

1.

Position the Temperature Control Knob to "FULL COLD."

2.

Remove the Temperature Control Cable housing from the Retention Clip (located on the heater case left of the evaporator), by pressing down on
the left side of the clip (figures 1 and 2).

A/C - Insufficient Cooling During Maximum A/C Operation|Page 5230 > < Air Conditioning Switch|Testing and Inspection