Rodeo S 4WD V6-3.2L (1999)
11. Remove needle bearing from inner shaft by using a remover J-26941 and sliding hammer J-2619-01.
12. Remove oil seal from front axle case.
NOTE: Be careful not to damage the front axle case.
INSPECTION AND REPAIR
Inspect the removed parts. If there are abnormalities such as wear and damage, take corrective action or replace.
VISUAL CHECK
1. Check and see if the inner shaft has such abnormalities as wear and damage.
2. When inspecting the inner shaft, be sure to check and see if its splined part is twisted, worn, or cracked. If so, replace with a new shaft. In case
such an abnormality in its gear part (a slide with sleeve), replace the shaft.
INNER SHAFT RUN-OUT