Rodeo Sport 2WD L4-2.2L (2002)
Slip Yoke: Service and Repair
Disassembly
Slip Joint Disassembly (6VD1 Model Only)
1. Lay the shaft horizontally on a bench and secure.
2. Indicate the original assembled position by marking the phasing of the shaft prior to disassembly.
3. Using the flat blade of a screwdriver, pry the loose end of the boot clamp upwards and away from the propeller shaft boot. Be careful not to
damage the boot.
4. When boot clamps becomes loose, remove by hand.
5. Repeat for the other boot clamp.
6. Remove the spline yoke assembly from the tube assembly, by securing the boot with one hand and pulling on the spline yoke.
7. Remove the boot from the tube assembly.