Rodeo Sport 2WD V6-3.2L (2001)
Keyless Entry Module: Service and Repair
ANTI-THEFT & KEYLESS ENTRY CONTROLLER
REMOVAL
1. Disconnect the battery ground cable.
2. Remove the glove box from the instrument panel assembly (1).
-
Refer to the Instrument Panel Assembly in Body Structure.
3. Remove the anti-theft & keyless entry controller (2).
-
Disconnect the connector.
-
Remove two fixing screws.
INSTALLATION
To install, follow the removal steps in the reverse order.
ANTI-THEFT & KEYLESS ENTRY CONTROL UNIT
REPLACEMENT
1. Remove and install the control unit.
-
Refer to Anti-theft & Keyless Entry Control Unit Removal and Installation.
2. Register ID code.
-
Refer to Anti-Theft Stamping Label/Plate Location in General Information - Rodeo or Anti-Theft Stamping Label/Plate Location in General
Information - Rodeo Sport.
3. Check that the keyless entry system works normally.