Rodeo Sport 2WD V6-3.2L (2001)
Exhaust Manifold: Service and Repair
Left Hand Side
Removal
1. Disconnect battery ground cable.
2. Disconnect 02 sensor connector.
3. Remove exhaust front pipe three stud nuts from exhaust side and two nuts from rear end of exhaust front pipe.
4. Remove exhaust manifold eight fixing nuts and remove exhaust manifold from the engine.
Installation
1. Install exhaust manifold and tighten exhaust manifold fixing nuts to the specified torque with new nuts.
Torque: 57 Nm (42 ft. lbs.)
2. Install exhaust front pipe and tighten three stud nuts and two nuts to the specified torque.
Torque:
Stud nuts: 67 Nm (49 ft. lbs.)
Nuts: 43 Nm (32 ft. lbs.)
3. Reconnect 02 sensor connector.