Rodeo Sport 2WD V6-3.2L (2001)
-
Handle with care to prevent damaging the condenser or radiator fin.
INSTALLATION
1. Install condenser assembly.
-
If installing a new condenser, be sure to add 30 cc (1.0 fl.oz.) of new compressor oil to a new one.
-
Tighten the condenser fixing bolts to the specified torque.
Torque: 6 N.m (52 lb.in)
2. Connect refrigerant line.
-
Tighten the inlet line connector fixing bolt to the specified torque.
Torque: 15 N.m (11 lb.ft)
-
Tighten the outlet line connector fixing bolt to the specified torque.
Torque: 6 N.m (52 lb.in)
-
O-rings cannot be reused. Always replace with new ones.
-
Be sure to apply new compressor oil to the O-rings when connecting the refrigerant line.
3. Connect pressure switch connector.
4. Install engine hood lock.
5. Install engine hood front end stay.
6. Install radiator grille.