Rodeo Sport 2WD V6-3.2L (2001)
crankshaft back to the 9 o'clock position.
5. Place the tensioner pusher in a soft-jawed vise, then slowly compress the tensioner pusher pin until it lines up with the two small holes in the
tensioner pusher housing.
6. Insert a straightened heavy duty paper clip through the holes in the housing. This will hold the pin in its compressed position.
NOTE:
A new tensioner pusher comes with its pin held compressed by a special wire. If you install a new tensioner pusher, save the wire for future
use.
7. Install the tensioner pusher:
-
Install the lower bolt loosely.
-
Push the tensioner pusher up against the tensioner pulley, then install the upper bolt, and torque it to 25 N.m (15 lb-ft).
-
Torque the lower bolt to 25 N.m (15 lb-ft).
8. Remove the wire or paper clip from the tensioner pusher, and remove the binder clips from the camshaft pulleys.
9. Verify the timing belt is correctly installed:
-
Rotate the crankshaft three complete turns.
-
Align the crankshaft timing pulley notch with the mark on the oil pump housing.
-
Check the green marks on both camshaft pulleys; they should line up with the valve cover timing marks.