Rodeo Sport 2WD V6-3.2L (2001)
2. When installing the steering column cover, be sure to route each wire harness as illustrated so that the harnesses do not catch on any moving parts.
3. Align the setting marks made when removing then install steering wheel.
Caution:
Never apply force to the steering wheel in direction of the shaft by using a hammer or other impact tools in an attempt to remove the
steering wheeL The steering shaft is designed as an energy absorbing uniL
4. Tighten the steering wheel fixing nut to the specified torque.
Torque: 34 Nm (25 lb ft)
5. Support the inflator module and carefully connect the module connector.
Note:
Pass the lead wire through the tabs on the plastic cover (wire protector) of inflator to prevent lead wire from being pinched.
6. Tighten bolts to specified torque.
Torque: 9 Nm (78 lb in)
7. Install driver knee bolster (reinforcement).
8. Install steering lower cover then install the engine hood opening lever.
9. Connect the SRS connectors.
10. Connect the battery terminal cable.
11. Turn the ignition switch to ON while watching warning light and check the light should flash 7 times and then go off. If lamp does not operate
correctly, refer to Restraints section.
