Rodeo Sport 2WD V6-3.2L (2001)
Inspection and Repair
Refer to Shock Absorber.
Installation
1. Set the G-sensor on the gusset (11).
2. Install 2 bolts (5), then tighten it to the specified torque.
Torque: 7 Nm (61 inch lbs.)
3. Connect the connector (10) to the harness and insert the connector (10) to the gusset (11).
4. Install the rear shock absorber (3).
5. Connect the connector (1) to the harness and insert the connector (1) to the bracket (4).
6. Insert the clip (2) to the bracket (4).
7. Connect the battery ground cable.