Rodeo Sport 2WD V6-3.2L (2001)
Shift Cable: Service and Repair
Removal
1. Set selector lever in "P" position.
2. Remove transfer control lever knob, lower cluster assembly, rear console, center console, selector lever knob and cover.
3. Disconnect inner cable by pulling projection on pin.
4. Press down claws and disconnect cable assembly.
5. Disconnect PCM harness connectors and remove nuts that fasten grommet in select cable assembly.
6. Disconnect inner cable.
(V6)
7. Slide sleeve and disconnect cable assembly.
8. Pull lock.
9. Draw select cable assembly into the interior side.