Rodeo Sport 2WD V6-3.2L (2001)
6. Remove two guide pins from main case.
7. Install servo cover gasket, cover, and four 13 mm screws. Tighten the screws to the specified torque.
Torque: 25 Nm (18 ft. lbs.)
8. Connect wiring harness to band control and shift solenoids.
9. Install roller and spring assembly to manual detent.
^
Install two 13 mm screws, and tighten them to the specified torque.
Torque: 20 Nm (15 ft. lbs.)
10. Install oil filter and three 13 mm screws. Tighten to the specified torque.
Torque: 20 Nm (15 ft. lbs.)
11. Tighten oil pan gasket, magnet, oil pan and sixteen 10 mm screws. Tighten the screws to the specified torque.
Torque: 11 Nm (96 inch lbs.)
12. Fill transmission through overfill screw hole of oil pan., using ATF DEXRON III.
13. Connect battery ground cable.