Rodeo Sport 2WD V6-3.2L (2001)
-
Be absolutely sure to apply body primer fully to the body.
NOTE: Immediately wipe off the primer left on the body or extruded sealant.
-
Attach the fastener to the indicated position of body with sealant as shown in the figure.
-
Apply the sealant to the circumference of glass as shown in the figure.
-
Insert the location pins on glass into the panel, push the glass against the panel, and bond them.
-
Attach the molding to the body with sealant.
-
Cure the bonding at a temperature of 20 degrees C -30 degrees C (68 degrees F -86 degrees F) for 24 hours.
-
Check the rear quarter glass for any signs of water leak.
2. Install rear quarter trim panel.