Rodeo Sport 4WD V6-3.2L (2002)
10. Remove the right luggage side trim cover.
-
Remove the jack and tool lid and take out the tools.
Then remove the fixing screw and pull the clips out from the body panel.
-
To remove the left luggage side trim cover, disconnect the accessory socket connector.
11. Remove the rear seat belt assembly.
-
Refer to Rear Seat Belt (LWB) or Rear Seat Belt (SWB) in Restraints.
12. Remove the seat belt cross bar assembly.
-
Remove the two sets of seven fixing bolts on the left and right sides. Note that on the soft top model, two sets of the fixing bolts are also used
to secure the tarpaulin frame assembly in place, and that on the resin top model, one set of the fixing bolts are also used to secure the resin top
in place.
Installation
To install, follow the removal steps in the reverse order, noting the following points.
1. Tighten the rear seat belt anchor bolts to the specified torque.
Torque: 39 N.m (29 lb ft)
2. Tighten the seat belt cross bar assembly fixing bolts to the specified torque.
Torque: 19 N.m (14 lb ft)