Rodeo Sport 4WD V6-3.2L (2002)
2. Remove wheel and tire assembly (1).
3. Remove Drum (2).
^
If difficulty is encountered in removing the drum:
-
Mark the position of the drum to the axle.
-
Make sure the parking brake is released.
-
Use a rubber mallet to tap gently on the outer rim of the drum and/or around the inner drum. Be careful to avoid damaging the drum.
4. Remove upper (other) return spring (6) and auto adjuster lever.
5. Remove lower return spring (5).
6. Remove hold-down spring and cups (4) and hold-down pin (15).
7. Remove adjuster assembly (12)
Leading Shoe Assembly With Upper Return Spring
8. Remove leading shoe assembly (8) with upper (inner) return spring (9).
Note: Do not over stretch the return spring.
9. Remove upper (inner) return spring (9).
10. Remove hold-down spring and cup (3) and hold-down pin (16).
11. Remove trailing shoe assembly (7) with parking brake lever (16).
12. Remove parking brake cable from parking brake lever (11).
13. Remove retainer (14), wave washer (13), and parking brake lever (11).
Brake Lining Inspection
Check the shoe assemblies for wear by removing brake drum.
Replace the shoe assemblies, if lining thickness is less than 1.0 mm (0.039 inch).
The shoe assemblies have a wear indicator that makes a noise when the linings wear to a degree where replacement required.
Minimum limit: 1.0 mm (0.039 inch)
Installation