Rodeo Sport 4WD V6-3.2L (2002)
Caution: Never apply force to the steering wheel in direction shaft by using a hammer or other impact tools in an attempt to remove the steering
wheel. The steering shaft is designed as an energy absorbing unit
Installation
1. Install steering wheel by aligning the setting marks made when removing.
Caution: Never apply force to the steering wheel in direction shaft by using a hammer or other impact tools in an attempt to remove the steering
wheel. The steering shaft is designed as an energy absorbing unit
2. Tighten the steering wheel fixing nut to the specified torque.
Torque: 34 Nm (25 ft. lbs.)
3. Connect horn lead.
4. Support the module and carefully connect the SRS connector.
Note: Pass the lead wire through the tabs on the plastic cover (wire protector) of inflator to prevent lead wire from being pinched.
5. Tighten bolts to specified torque.
Torque: 9 Nm (78 inch lbs.)
6. Connect the yellow 2-way SRS connector located under the steering column.
7. Connect the battery "-" terminal cable.
8. Turn the ignition switch to "ON" and observe the warning light. Light should flash 7 times.
If lamp does not operate correctly, refer to Restraints System.
