Rodeo Sport 4WD V6-3.2L (2002)
caliper.
7. Loosen the caulking around the front drive shaft nuts.
8. Remove the nuts and discard them (they cannot be reused).
9. Remove the 4 bolts fixing the hub unit bearing to the knuckle.
Apply penetrating oil to the bearing and knuckle contact surfaces if the surfaces are stuck together because of rust.
10. Temporarily install long bolts to 2 of the fixing bolt holes (the bolts must have the same diameter and thread width).
11. Strike the long bolts with a hammer to loosen and remove the hub unit bearing from the knuckle.
-
Take care not to strike the front drive shaft.
-
Take care not to drop the bearing.
12. Remove the ABS rotor sensor from the bearing.
13. Remove the wheel pin.
Inspection
Inspect the parts listed below for abrasion, breakage, and other abnormal conditions.
Repair or replace the parts as required.
-
Disc
-
Caliper
-
Drive shaft oil seal
-
ABS sensor rotor
-
Wheel pin
-
Hub unit bearing
Reassembly
