Stylus L4-1588cc 1.6L DOHC (4XE1-W) (1991)
/Page-942006.png)
14.
(Driver front seat belt buckle only)
Position the switch assembly over the plastic pins on the new lower cover. Apply gentle pressure to the corners of the switch assembly to snap it
into place (Figure 8).
IMPORTANT!
Do not apply pressure to the center of the switch assembly - this could damage it.
15.
(Driver front seat belt buckle only)
Press the switch wires into the clamps and slide the switch upwards to its original position (Figure 9).
16.
Press the release button and carefully assemble the two cover halves. Press the two cover halves together until a snap is heard and/or felt.
17.
Test for proper seat belt buckle operation by inserting the latch tongue into the seat belt buckle, pulling firmly on the webbing to make sure that
the tongue latches, and pressing the release button to make sure that the tongue unlatches. Repeat this step five (5) times.
IMPORTANT!
If the front seat belt buckle fails to latch or unlatch properly, call tile Isuzu Care Team Line at 1-800-666-3411 for further instructions.
18.
Reconnect the negative battery cable.
19.
Check for proper seat belt warning lamp operation.
