Trooper (4 Door) V6-3165cc 3.2L DOHC (6VD1) (1992)
Neutral Safety Switch: All Technical Service Bulletins
A/T Mode Switch - No Crank In Neutral Position
BULLETIN NUMBER
SB93-05-011
ISSUE DATE
June 1993
GROUP
TRANSMISSION
RODEO (UC) AND TROOPER (UX) NO START IN NEUTRAL
AFFECTED VEHICLES
1991-93 Rodeo (UC) and 1992-93 Trooper (UX) models equipped with V6 engine and automatic transmission before the following VINS:
^
VIN P4310980 Rodeo 2-wheel drive
^
VIN P4314257 Rodeo 4-wheel drive
^
VIN P7906876 Trooper
SERVICE INFORMATION
Some affected vehicles may experience a "no start" (no crank) condition when the A/T selector lever is in the neutral position, caused by A/T mode
switch failure. Follow the diagnosis procedure in this Service Bulletin to determine if the mode switch requires replacement.
If mode switch replacement is necessary, install the mode switch listed in the "Parts Information" section of this Bulletin.
SERVICE PROCEDURE
NOTE:
Refer to the appropriate Electrical Troubleshooting Manual for connector number references.
Check mode switch operation as follows:
1.
Disconnect the starter solenoid connector (C130 on Trooper; C112 on Rodeo).
2.
On 3.2L V6 models, remove the air cleaner assembly.