Trooper II L4-2238cc DSL (C223) (1987)
8.
Install two new gasket strips to sides of lamp housing, using rubber cement adhesive. See Figure 1. American Isuzu Motors Inc. recommends using
Three Bond 1521 adhesive for this procedure. Apply a thin, even layer of adhesive along each side of the lamp housing and to one side of each
gasket. Wait 3 to 5 minutes before installing gaskets. Apply pressure to gaskets for complete application.
9.
Install a new triangular gasket to corner of lamp assembly. Peel backing from gasket and install to lamp assembly as shown in Figure 1.
10.
Reinstall rear combination lamp assembly as described in the appropriate Workshop Manual.
11.
Gasket set services both sides of vehicle.
PARTS INFORMATION
Part No.
Description
8-94367-718-0
Lamp Gasket Set
(services both sides)
FLAT RATE MANUAL UPDATE INFORMATION
OPERATION
OPERATION
TASK
SPECIAL
TIME
ADDITIONAL
NUMBER
INSTR.
INSTRUCTIONS
Lamp Gasket Set
041307
Install
Both sides
.8
Includes 041303 & 041403
R&R Rear Combination Lamp (Both sides)