Trooper II L4-2559cc 2.6L SOHC (4ZE1) (1989)
Fig. 18 Measuring axle shaft snap ring clearance
12.
Install tool J-36836 to axle shaft by tool J-36835-2 or equivalent, Fig. 17, then measure clearance ``t'' Fig. 18, between tool and snap ring groove
of axle shaft using a feeler gauge.
13.
Clearance should be .0039. If clearance is larger than specified, select proper shim to meet specification.
14.
Remove tool J-36836 and ensure inner cam stays in place. If inner cam is removed, repeat steps 10-13.
Fig. 19 Application of drive clutch assembly lubricant (Part 1 of 2)
Fig. 19 Application of drive clutch assembly lubricant (Part 2 of 2)
Fig. 20 Installation of axle snap rings & shims
15.
Apply multipurpose grease or bearing grease to portions of clutch assembly as shown in Fig. 19, then align cut part of drive clutch assembly with
the concave part of inner cam.
16.
Engage cam teeth of drive clutch assembly to that of the inner cam by turning axle shaft.
17.
Install snap ring and shims as follows:
a. Install tool J-36835-2 or equivalent, to axle Fig. 20.
b. Install snap ring to snap ring tool.
c. Install tool driver J-36835-1 or equivalent.
d. Pull axle shaft out by pulling tool J-36835-2 and install snap ring to axle by pushing tool J-36835-1, then remove tool. Ensure snap ring is