Trooper LS V6-3.5L (1998)
5. Install piston dust boot; when inserting the piston into the cylinder, use finger pressure only and do not use a mallet or other impact tool, since
damage to the cylinder wall or Diston seal can result.
6. Install dust boot ring and apply special grease (approximately 1 g) to the piston and attach the dust boot to the piston and caliper. Insert the dust
boot ring into the dust boot.
7. Install guide bolt and lock bolt dust boot.
8. Install lock bolt and guide bolt and tighten the bolt to the specified torque.
Torque: 74 Nm (54 ft. lbs.)
9. Install the dust boot on the support bracket after applying special grease (approximately 1 g) onto the dust boot inner surface. Apply special grease
onto the lock bolt and guide bolt setting hole of the support bracket.
