Trooper LS V6-3.5L (1998)
NOTE:
1. Do not use an air compressor, as the air from the compressor is mixed with compressor oil.
2. When installing the master cylinder onto the vacuum booster, always adjust the vacuum booster push rod..
3. After the master cylinder is installed onto the vehicle, check for leakage' pedal travel and pedal free play.
INSTALLATION
1. Install spacer and the 2 gaskets.
2. Install master cylinder, when replacing the master cylinder or vacuum booster or both, always measure the vacuum booster push rod protrusion
and adjust it as necessary.
3. Install P&B valve and bracket.
4. Install 2 attaching nuts and tighten the attaching nuts to the specified torque.
Torque: 13 Nm (113 inch lbs.)
5. Install brake pipes and tighten the brake pipe to the specified torque.
Master Cylinder Side
Torque: 12 Nm (104 inch lbs.)
Others
Torque: 16 Nm (12 inch lbs.)
6. Connect electrical connector.
