Trooper LS V6-3.5L (1998)
Electronic Brake Control Module: Service and Repair
REMOVAL
1. Remove battery assembly.
2. Remove harness connector.
3. Remove Electronic Hydraulic Control Unit (EHCU) fixing nuts.
4. Remove brake pipes.
^
After disconnecting brake pipe, cap or tape the openings of the brake pipe to prevent the entry of foreign matter.
5. Remove hydraulic unit fixing nuts.
INSTALLATION
To install, follow the removal steps in the reverse order, noting the following points:
Torque
Hydraulic unit fixing nuts: 22 Nm (16 ft. lbs.)
Ground cable: 14 Nm (10 ft. lbs.)
Brake pipe (joint bolts): 16 Nm (12 ft. lbs.)
^
After installing the hydraulic unit, bleed brakes completely.