Trooper LS V6-3.5L (1998)
Cruise Control Switch: Service and Repair
Starter Switch
Removal
1. Disconnect the battery ground cable.
2. Remove the front console assembly (1).
3. Remove the lower cluster assembly (2).
4. Remove the instrument panel driver lower cover assembly (3).
5. Remove seven screws to remove the steering cowl (6).
6. Disconnect the connector, remove the screw (4) and then remove the starter switch (5).
Installation
To install, follow the removal steps in the reverse order, noting the following point.
1. When installing the steering cowl (10), be sure to pass the harnesses through the route as shown so that the starter switch harness (7), the