Trooper LS V6-3.5L (1998)
2. Align timing mark on intake camshaft (one dot for right bank, two dot for left bank) and exhaust camshaft (one dot for right bank, two dots for
left bank) to timing mark on camshaft drive gear (one dot).
3. Tighten twenty bolts on numerical order an one side bank as shown in the illustration.
Torque: 10 Nm (89 inch lbs.)
5. Install cylinder head cover RH.
-
Refer to installation procedure for Cylinder Head Cover RH.
6. Install cylinder head cover LH.
-
Refer to installation procedure for Cylinder Head Cover LH.
7. Install timing belt.
-
Refer to installation procedure for Timing Belt.
8. Install crankshaft pulley.
-
Refer to installation procedure for Crankshaft Pulley.
Accelerator pedal cable adjustment
1. Loosen adjusting nut and lock nut.
2. Pull outer cable while closing fully the throttle valve.
3. Tighten adjusting nut and lock nut temporarily.
