Trooper LS V6-3.5L (1998)
NOTE: Do not apply engine oil to the bearing back faces and connecting rod bearing fitting surfaces.
2. Install oil gallery and tighten the bolts in two steps, in the order shown in illustration.
Torque:
1st step: 29 Nm (21 ft. lbs.)
2nd step: 55° - 65°
3. Install oil pipe with O-ring.
Torque: 10 Nm (89 inch lbs.)
4. Install oil strainer assembly with O-ring.
Torque: 25 Nm (18 ft. lbs.)
5. Install crankcase with Oil Pan.
-
Refer to installation procedure for Oil Pan and Crankcase.
6. Install cylinder head assembly.
-
Refer to installation procedure for Cylinder Head.
