Trooper LS V6-3.5L (1998)
Front Crankshaft Seal: Service and Repair
REMOVAL
1. Disconnect battery ground cable.
2. Drain engine oil.
3. Remove crankshaft pulley.
-
Refer to removal procedure for Crankshaft Pulley.
4. Remove timing belt.
-
Refer to removal procedure for Timing Belt.
5. Remove timing pulley from crankshaft.
6. Remove oil pump oil seal using a sealer puller.
NOTE: Take care not to damage sealing surfaces of oil pump and crankshaft when removing oil seal.
INSTALLATION
1. Install oil pump oil seal, apply engine oil to oil seal lip, then install oil seal using J-39202 installer.
2. Install timing pulley to crankshaft.
3. Install timing belt.
-
Refer to installation procedure for Timing Belt.
4. Install crankshaft pulley.
-
Refer to installation procedure for Crankshaft Pulley.
5. Refill engine oil until full level.
