Trooper LS V6-3.5L (1998)
NOTE: It is recommended for easy installation that the belt be secured with a double clip after it is installed to each Pulley
5. Install crankshaft pulley temporarily and tighten center bolt by hand (do not use a wrench).
Turn the crankshaft pulley clockwise to give some belt slack between the crankshaft timing pulley and the RH bank camshaft drive gear pulley.
2. Install pusher and tighten bolt to the specified torque.
1. Install the pusher while pushing the tension pulley to the belt.
2. Pull out pin from the pusher.
NOTE: When reusing the pusher, press the pusher with approximately 100Kg to retract the rod, and insert a pin (1.4 mm piano wire).
3. Remove double clips from timing belt pulleys.
Turn the crankshaft pulley clockwise by two turns.
Torque: 25 Nm (18 ft. lbs.)
