Trooper LS V6-3.5L (1998)
11. Disconnect the wiring harness connectors located under the steering column, then remove combination switch and SRS coil assembly.
NOTE: The SRS coil is a part of the combination switch assembly, which can not be replaced separately. Therefore, be sure not to remove the
SRS coil from the combination switch assembly.
INSTALLATION
1. Install combination switch and SRS coil assembly. After installation of combination switch assembly, connect the combination switch wiring
harness connector and the SRS 2-way connector located under the steering column. Then turn the SRS coil counterclockwise to full, return about 3
turns and align the neutral mark.
CAUTION: When turning the SRS coil counterclockwise to full, stop turning if resistance is felt. Forced further turning may damage to the cable
in the SRS coil.
2. When installing the steering column cover, be sure to route each wire harness as illustrated so that the harnesses do not catch on any moving parts.
3. Align the setting marks made when removing then install steering wheel.
