Trooper LS V6-3.5L (1998)
CAUTION: Never apply force to the steering wheel in direction of the shaft by using a hammer or other impact tools in an attempt to remove the
steering wheel. The steering shaft is designed as an energy absorbing unit.
4. Tighten the steering wheel fixing nut to the specified torque.
Torque: 34 Nm (25 ft. lbs.)
5. Support the inflator module and carefully connect the module connector.
CAUTION: Never use the air bag assembly from another vehicle. Use only the air bag assembly for "UX".
NOTE: Pass the lead wire through the tabs on the plastic cover (wire protector) of inflator to prevent lead wire from being pinched.
6. Secure the module with one bolt to relieve weight on the wire connector.
7. Tighten bolts to specified sequence as illustrated.
Torque: 8 Nm (69 inch lbs.)
8. Install steering lower cover then Install the engine hood opening lever.
9. Install lower cluster assembly
10. Install the transmission (for M/T) and transfer control lever knob, then install front console assembly.
11. Connect the wiring harness connectors.
12. Connect the battery "-" terminal cable.
13. Turn the ignition switch to "ON" while watching warning light and check the light should flash 7 times and then go off.
