Trooper LS V6-3.5L (1998)
Fluid - A/T: Testing and Inspection
CHECKING TRANSMISSION FLUID LEVEL AND CONDITION
Checking fluid level and condition (color and odor) at regular intervals will provide early diagnosis information about the transmission. This
information may be used to correct a condition that, if not detected early, could result in major transmission repairs.
IMPORTANT.- When new, automatic transmission fluid is red in color. As the vehicle is driven, the transmission fluid will begin to look
darker in color. The color may eventually appear light brown.
A dark brown color with burnt odor may indicate excessive fluid deterioration and signal a need for fluid change.
FLUID LEVEL
When adding or changing fluid, use only DEXRON (R) -III.
CAUTION: DO NOT OVERFILL. Overfilling will cause foaming, loss of fluid, abnormal shifting and possible damage to the transmission.
1. Park the vehicle on level ground and apply the parking brake firmly.
2. Check fluid level with engine running at idle.
NOTE: Be sure that transmission fluid temperature is below 30 ° C (86 ° F).
3. Move the selector lever through all gear ranges.
4. Move the selector lever to "Park".
5. Let engine idle for 3 minutes and open the overfill screw (1).
6. Add released transmission fluid until it flows out over the overfill screw opening.
7. Let engine idle until a fluid temperature between 32 ° C (90 ° F) and 57 ° C (135 ° F) is reached, then close the overfill screw (1).
Torque: 38 Nm (28 ft. lbs.)
NOTE: Check transmission fluid temperature with scan tool.
Minimum fluid level 57 ° C (135 ° F)
Maximum fluid level 32 ° C (90 ° F)
