Trooper LS V6-3.5L (1998)
Sensing And Diagnostic Module: Service Precautions
Connectors
WARNING: To avoid accidental deployment and possible injury, always connect the protective short connector (RED) to the driver's airbag
connector, and disconnect the front passenger's airbag connector (automati cally shorted) before working near any SRS wiring.
1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
2. Disconnect the battery negative cable, then disconnect the positive cable from the battery, and wait at least three minutes.
3. Disconnect the airbag connectors.
Disconnecting the Airbag Connectors
Driver's Side:
^
Remove the access panel from the steering wheel, then remove the short connector (RED) from the panel.
^
Disconnect the 3P connector between the driver's airbag and cable reel, then connect the short connector (RED) to the airbag side of the
connector.
Front Passenger's Airbag Connectors / SRS Main Harness
Front Passenger's Side:
^
Remove the dashboard compartment.
^
Disconnect the 2P connector between the front passenger 5 airbag and SRS main harness.
Disconnecting The SRS Connector At The Under-dash Fuse Box
CAUTION: Avoid breaking the connector; it's double- locked.
