Trooper LS V6-3.5L (1998)
* I/P steering column reinforcement plate - Inspect for any distortion, bending, cracking, or other damage.
* I/P braces - Inspect for any distortion, bending, cracking, or other damage.
* Seat belts and mounting points - Refer to "Seat Belts"/Service And Repair.
SDM Replacement Guidelines
SDM replacement policy requires replacement of SDM, after crash involving air bag deployment when "SRS Warning Lamp" turn "ON" Refer to
Testing and Inspection/Diagnostic Trouble Code Charts. See: Testing and Inspection/Initial Inspection and Diagnostic Overview See: Service and Repair
Wiring Damage
If any SRS wire harness is damaged, it should be replaced. Don't repair SRS. It is replace only.
SRS Connector (Plastic Body and Terminal Metal Pin) Damage
If any connector or terminal in the SRS wire harness (except pigtails) is damaged, it should be replaced.
SRS Wire Pigtail Damage
If the wiring pigtail (a wire or wires attached directly to the device, not by a connector) is damaged, the entire component (with pigtail) must be replaced.
Examples of "pigtail" components are the driver air bag assembly, the passenger air bag assembly, and the SRS coil assembly.
SRS Connectors
CAUTION: The special yellow color connectors are used for supplemental restraint system-air bag circuit. When removing the cable harness, do not
pull the cables. Otherwise, cable disconnection may occur. When connect the SRS connector, insert the connector completely. Imperfect locking may
cause malfunction of SRS circuit.
Removal
To remove the connector, hold the cover insulator(1) and pull it. The cover insulator slides and lock will be released. Do not hold the socket insulator(2).
