Trooper LS V6-3.5L (1998)
CAUTION: When turning the SRS coil counterclockwise to full, stop turning if resistance is felt. Forced further turning may damage the cable in
the SRS coil.
3. Connect the wiring harness connectors located at the base of steering column.
4. Install the air conditioning lower duct.
5. Install the steering column cover.
CAUTION: When installing the steering column cover, be sure to wire (through each harness) as Illustrated so that the harness starter switch,
combination switch and SRS coil may not catch wiring.
6. Install the driver knee bolster assembly.
7. Install the steering lower cover and engine hood opening lever.
8. Install the steering wheel and align the selling marks.
9. Tighten the steering wheel fixing nut to the specified torque.
Torque: 34 N.m (25 lb.ft)
10. Connect horn lead.
11. Connect air bag to wiring harness connector.
NOTE: Pass the lead wire through the tabs on the plastic cover (wire protector) of air to prevent lead wire from being pinches.
