Trooper LS V6-3.5L (1998)
11. Move the front wheels to the straight ahead position, then use steering wheel remover J-29752 to remove the steering wheel.
CAUTION: Never apply force to the steering wheel in direction of the shaft by using a hammer or other impact tools in an attempt to remove the
steering wheel. The steering shaft is designed as an energy absorbing unit.
WARNING: THE INFLATOR MODULE SHOULD ALWAYS BE CARRIED WITH URETHANE COVER AWAY FROM YOUR
BODY AND SHOULD ALWAYS BE LAID ON A FLAT SURFACE WITH THE URETHANE SIDE UP. THIS IS NECESSARY
BECAUSE A FREE SPACE IS PROVIDED TO ALLOW THE AIR CUSHION TO EXPAND IN THE UNLIKELY EVENT OF
ACCIDENTAL DEPLOYMENT. OTHERWISE, PERSONAL INJURY MAY RESULT.
12. Remove steering column cover.
13. Disconnect the wiring harness connectors located under the steering column.
14. Remove the combination switch assembly with SRS coil.
NOTE: The SRS coil is a part of the combination switch assembly, which cannot be replaced separately. Therefore, be sure not to remove the
SRS coil from the combination switch assembly.
15. Remove snap ring.
16. Remove cushion rubber.
17. Remove shift lock cable (for A/T).
18. Disconnect the starter switch harness connector located under the steering column, then remove lock cylinder assembly.
INSTALLATION
1. Install lock cylinder assembly.
2. Install shift lock cable (for A/T).
3. Install cushion rubber.
