Trooper LS V6-3.5L (1998)
4. install snap ring.
5. Install combination switch and SRS coil assembly. After installation of combination switch assembly, connect the combination switch wiring
harness connector and the SRS 2-way connector located under the steering column.
6. Turn the SRS coil counterclockwise to full, return about 3 turns and align the neutral mark.
CAUTION: When turning the SRS coil counterclockwise to full, stop turning if resistance is felt. Forced further turning may damage to the cable
in the SRS coil.
7. When installing the steering column cover, be sure to route each wire harness as illustrated so that the harnesses do not catch on any moving parts.
8. Install steering wheel by aligning the setting marks made during removal.
CAUTION: Never apply force to the steering wheel in direction of shaft by using a hammer or other impact tools in an attempt to remove the
steering wheel. The steering shaft is designed as an energy absorbing unit.
9. Tighten the steering wheel fixing nut to the specified torque.
Torque: 34 Nm (25 ft. lbs.).
10. Support inflator module and carefully connect the module connector, then install inflator module.
CAUTION: Never use the air bag assembly from another vehicle. Use only the air bag assembly for "UX".
